The charge level is indicated
when the charging cable is connected correctly to the ND250 and 110volts
AC ) by a tri-color LED ( Light Emitting Diode) inside the charging port
above the connection for the charging cord. The LED changes color from
green to yellow
to red depending on the level
of charge obtained. Unless the battery has been completely discharged,
a full charge will take approximately 12 hours. In the case of full discharge,
allow 24 hours.
NOTE: never charge the light for
more than 24 hours.
Prior to charging, determine the following:
--the light is turned off
--the recharging cord is plugged
firmly
into both the ND250 and an
active wall socket
|
Step 1
Unscrew the black charging port cover
located on the end of the ND250.
Step 2
Plug the female end of the charging cord
firmly into the port provided.
Step 3
Plug the male end of the cord into an
active 110 volt outlet.
Step 4
Observe the LED above the cord in the
charging port. It will begin glowing green, changing to yellow at approximately
50-60% of full charge, then changing to red at full charge.
Step 5
After the ND250 reaches full charge, remove
the recharging cord and re-install the charging port cover, checking to
make sure the “o-ring” under the cover is seated properly to insure a watertight
seal.
|
